Timed out while waiting for daemon to fetch config from device

Help
#1

Question/Issue: I am getting Time out message on the terminal while I run edge-impulse-daemon after following the guide to flash the firmware to the nrf9160dk, I have attached a screenshot of the same below:

image
image706×592 100 KB

I have used edge impulse on other fully supported board, and I wanted to try the features on the nrf9160dk too, I did try changing the USB cable but that did not solve my problem.

Any help would be much appreciated.

#2

Hi @sriharibg,

I recommend flashing the connectivity bridge with the latest firmware. Please see the following discussions for more information: