Run without running "edge-impulse-run-impulse --continuous"

Fytos · October 15, 2020, 2:28pm

Hello,
Following my previous post:

I can now run my impulse locally and have the digital outputs, which I set on my own as you guided me.

My question is, how can I run it independently? I would like to build a script and upload it to my Arduino and then run it every time I power it on, without running edge-impulse-run-impulse --continuous and selecting COM ports, etc. I don’t need a serial out.

Is this possible?

Cheers

janjongboom · October 15, 2020, 3:46pm

@Fytos

Add run_nn_continuous_normal() right before this line:

github.com

edgeimpulse/firmware-arduino-nano-33-ble-sense/blob/39fa92ae1b28e318e90654eec09bd2c6d0b4f708/src/setup.cpp#L109


        ei_printf("Failed to initialize configuration (%d)\n", cr);
    }
    else {
        ei_printf("Loaded configuration\n");
    }


    ei_at_register_generic_cmds();
    ei_at_cmd_register("RUNIMPULSE", "Run the impulse", run_nn_normal);
    ei_at_cmd_register("RUNIMPULSECONT", "Run the impulse continuously", run_nn_continuous_normal);


    repl.start_repl();
    main_application_queue.dispatch_forever();
}