Sampling Failed Nicla Voice

Question/Issue:
[Hello, I am able to connect the Nicla voice to my project. However, when trying to collect data I am receiving the notifcation as shown below. Also in the portal is mentions sensor selection not supported and the frequency is that neither.

Many thanks in advance.

Kind regards,
Louis

Project ID:
[16757]

Notification:

[WS ] Incoming sampling request {
path: ‘/api/training/data’,
label: ‘Edge Impulse’,
length: 5000,
interval: 0,
hmacKey: ‘5575978b924ca1b390d1365a1621e7be’
}
[SER] Configured upload settings
[SER] Could not find file name line in sample response No handler for command! (AT+SAMPLESTART)
[WS ] Failed to sample data Could not find file name line in sample response No handler for command! (AT+SAMPLESTART)']

Hi @lvantienhoven

Did you manage to get to the route of your issue? It looks like it could be a misalignment with the CLI and Firmware versions used to test. Can you update the Nicla firmware and CLI to the latest and test again?

If not this then we can try manually setting the sampling rate via the CLI.

Best

Eoin

@ei_francesco fyi