Hi,
I’m using the main board and camera board on Windows 10.
I downloaded the firmware yesterday and flushed the board.
To flash successfully I had to change the baud rate to 115200.
I’m currently not able to connect to edge impulse
C:\Users\Harald\Downloads\EdgeImpulse\sony-spresense>edge-impulse-daemon
Edge Impulse serial daemon v1.13.10
Endpoints:
Websocket: wss://remote-mgmt.edgeimpulse.com
API: https://studio.edgeimpulse.com/v1
Ingestion: https://ingestion.edgeimpulse.com
[SER] Connecting to COM4
[SER] Serial is connected, trying to read config…
[SER] Failed to get info off device Timeout when waiting for > (timeout: 5000) onConnected
[SER] Serial is connected, trying to read config…
[SER] Failed to get info off device Timeout when waiting for > (timeout: 5000) onConnected
Tried with --clean option, same result.
Tried as Administartor, same result.
Anything missing in my setup?
Any suggestions how to get this done?
Thanks
Harald